CEL-MAR ADA-13040MG Manuale Utente Scaricare il pdf (Pagina 20)

Fig. 22. Example configuration for communication with MODBUS-MASTER devices – choice of devices and protocols

Set the options in section Modbus RTU Settings like on the figure below and press [Apply].

Fig. 23. Example configuration for communication with MODBUS-MASTER devices – Modbus RTU setting

Then select section Slave Destinations (Packet Routing) – figure below.

In this section press [Add], enter the IP address of Slave type devices, to which Master will send requests and receive responses.

Fig. 24. Example configuration for communication with MODBUS-MASTER devices – table configuration of SLAVE type

devices

In section Destination Settings (fig. below) set the options of requests from Master device to Slave device, in fields:

– Host name - enter IP address of Slave device.

– Protocol - set protocol which will be send to Slave device – in this case will be Modbus/TCP.

– Transport - set TCP protocol .

– Network port- set port 502.

Press [Apply] for saving configuration. Then press again [Add] for adding another Slave device.

Then select section Slave Destinations (Packet Routing), when all Slave devices are added and set, press [Apply].

ADA-13040MG

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Nessun commento

CEL-MAR ADA-13040MG Manuale Utente Pagina 20